This function is discontinuous at (x,y)=(0,0). The limit of f(x,y) along every straight line through the origin is 0 (as shown for the three lower yellow curves). However, the function has a different limit along every parabola through the origin - as shown by the upper yellow curve. In fact, the parabolas through the origin are exactly the level sets of the surface.
Tuesday, November 22, 2016
Discontinuous Surface
Discontinuous Surface
12.3 Limits and continuity
Note: Section numbers refers to Calculus, Early Transcendentals (2nd edition) by Briggs, Cochran, and Gillett.
The function
is discontinuous at (x,y)=(0,0).
The graph is a surface of fixed height along each line through the origin - a very hard concept to wrap the mind around. This creates the fold in the middle. Note in the print below that there are four fixed height lines (in purple) to emphasize this strange fact.
The title of this post reflects the fact that the graph looks very much like a specialty pasta (See http://recipes.wikia.com/wiki/File:Funghini.jpg).
Tangent Space of Twisted Cubic
Tangent Space of a Twisted Cubic
A twisted cubic is the curve
. This is a smooth, rational curve C of degree three in projective 3-space P3. It is a fundamental example of a skew curve. It is essentially unique, up to projective transformation (the twisted cubic, therefore). It is generally considered to be the simplest example of a projective variety that is not linear or a hypersurface, and is given as such in most textbooks on algebraic geometry. It is the three-dimensional case of the rational normal curve, and is the image of a Veronese map of degree three on the projective line.
(Information obtained from Wikipedia).
This design was created by Conor Nelson in Mathematics through 3D Printing, taught by Dr. Evelyn Sander in Spring 2016, and printed at the Math Makerlab, GMU.
Friday, July 1, 2016
Thursday, June 9, 2016
Calibration
Here is a warning for those who are considering owning a 3D printer.
This is what it takes to calibrate the dual extruder on the Lulzbot TAZ5. Each of the small cubes takes over an hour to make, so this was around 2 weeks worth of work.
Not to speak of just extruding 100 mm of filament over and over again to make sure the measured extrusion rate was just right.
And printing post-calibration prints to get everything working just right:
And some finer adjustments on a longer print.
This is what it takes to calibrate the dual extruder on the Lulzbot TAZ5. Each of the small cubes takes over an hour to make, so this was around 2 weeks worth of work.
Not to speak of just extruding 100 mm of filament over and over again to make sure the measured extrusion rate was just right.
And printing post-calibration prints to get everything working just right:
And some finer adjustments on a longer print.
USA SEF
On April 16, 2016, a series of my 3D prints were featured at the SIAM booth at the USA Science and Engineering Festival. Here are a few photos and a movie of the nested platonic solids by Jack Love and I which was the feature puzzle of the exhibit.
Friday, May 27, 2016
Earning my engineering badge
Our very nice pull out sliding kitchen drawers have a weak spot in the brackets holding them at the back.
STL file in meshlab:
Here it the bracket in action:
My first non mathematical design!
I have just earned my engineering badge by designing a replacement bracket in OpenSCAD.
My first non mathematical design!
Subscribe to:
Posts (Atom)



















